World Wind Forums - View Single Post - C# code to convert DD to UTM .. here it is !!

Hactic · 06-21-2007, 08:02 PM

Thank you all for posting back at me. I value the input. It may look like I'm re-inventing the wheel and to be honest .. that's exactly what I'm doing. I finished the code to convert UTM to Lat/long and it's working well.

I know that What_nick is making a similar projection conversion in pluginSDK, so I might as well wait to prevent me from doing double work. Currently I'm working on implementing this in MathEngine.cs. I'm thinking about posting that instead of continiously dumping code in here. Two birds with one stone. Perhaps I'm going to rattle a few dev cages and run this particular topic by them, if they're not reading it already. Although it's an open forum and that bits of code are always more than welcome , I'm still fairly new on WW and therefore unaware of any code of conduct and/or the hierachie in here.

Cheers

06-21-2007, 08:02 PM	#8
Hactic Member Join Date: May 2007 Posts: 48	Thank you all for posting back at me. I value the input. It may look like I'm re-inventing the wheel and to be honest .. that's exactly what I'm doing. I finished the code to convert UTM to Lat/long and it's working well. I know that What_nick is making a similar projection conversion in pluginSDK, so I might as well wait to prevent me from doing double work. Currently I'm working on implementing this in MathEngine.cs. I'm thinking about posting that instead of continiously dumping code in here. Two birds with one stone. Perhaps I'm going to rattle a few dev cages and run this particular topic by them, if they're not reading it already. Although it's an open forum and that bits of code are always more than welcome , I'm still fairly new on WW and therefore unaware of any code of conduct and/or the hierachie in here. Cheers Last edited by Hactic; 06-21-2007 at 08:05 PM.